Connecting To A Pressureless Water Supply - Stihl RB 302 Mode D'emploi

English
Connection to the drinking water
main
When hooking up to the drinking water
main, a backflow preventer (Type BA in
accordance with EN 1717) must be
installed between the water tap and the
hose.
Follow the rules laid down by the local
water supply company to prevent water
flowing back from the high-pressure
cleaner into the drinking water main.
8
All manuals and user guides at all-guides.com
Connecting to a
pressureless water supply
N
Connect the machine to the
pressurized water supply and start it
up briefly in accordance with the
Instruction Manual
N
Switch off machine
N
Disconnect the high-pressure hose
N
Replace water intake hose with
suction hose (special accessory)
Always use the connecting element
supplied with the intake hose to connect
the hose. The standard connecting
elements are watertight only when used
with a pressurized water supply and for
this reason are not suitable for suction
operation.
N
Fill the suction hose with water and
immerse the suction cup of the
suction hose in the water tank – do
not use dirty water
As a rule, it is advisable to use a
water filter.
N
Switch on the machine
N
Wait until a steady jet exits the high-
pressure hose connection
N
Switch off machine
N
Connect high-pressure hose
N
Switch on the machine with the
spray gun open
N
Actuate the spray gun several times
briefly in order to bleed the air out of
the machine as quickly as possible
Switching On
N
Turn on water supply
The machine may only be
switched on when the water intake
hose is connected and the water
supply has been turned on.
Otherwise the machine may be
damaged due to lack of water.
N
Completely unroll the high-pressure
hose
N
Start the engine as described in the
engine manual.
N
Point the spray gun at the object to
be cleaned – never at persons!
RB 302, RB 402 PLUS