Dräger X-zone 5500 Notice D'utilisation page 49

4.2.9 Terminating group in an alarm situation
If the main device can no longer be found for a group device
(communication LED flashes red), the grouping for this device
can be cleared.
To ungroup the group:
1. Press the key on the group device to open the menu.
OK
2. Select and confirm .
3. Select and confirm to delete the group affiliation.
or
Press key on the group device for a long time.

Group affiliation is deleted.

4.2.10 Open quick menu of the X-am 5x00
Use this function to open the quick menu of the X-am 5x00
To open the quick menu:
1. Press the key to open the menu.
OK
2. Select Quick to display the quick menu of the X-am
5x00.
4.2.11 Open status indicator from external module
NOTICE
i i
This function is only available if the Modbus function
using the PC software CC-Vision has been enabled.
1. Press the key on the main device to open the menu.
OK
2. Select Modbus to
display the status indicator.
Legend:
1 Equipment name
2 GSM signal strength
3 Phone number
4 Connection to the X-zone
5 GPS position
6 Email (enabled)
7 SMS (disabled)
8 Cloud (enabled)
Dräger X-zone 5500 / 5800
1
Modbus
xxxxxxxxx
4
5
GPS
6 7 8
05933112.eps
4.2.12 Alternative key commands
Forming a new group
A maximum of 15 group devices can be assigned to a main
device. Group affiliation is saved in the corresponding X-
zone until the group is terminated.
1. Gather all the devices for the group in one area.
2. Switch on the devices (see "Switching on the instrument"
on Page 41).
3. Select an X-zone as the main device.
4. Press key on the main device briefly.
X-zone becomes main device.

Search run for the group devices is started.

Grouping LED main device: red-green flashing slowly.

Grouping LED for potential group devices: green

flashing slowly.
NOTICE
i i
The grouping LED flashes green for all non-grouped
X-zone devices within range of the main device.
5. Press key briefly and consecutively for all desired group
devices.
X-zone included in group.

Grouping LED group device: lit in green.

6. Press key on the main device briefly.
Search run is terminated.

Grouping LED main device: lit in red-green.

Grouping is completed.

Group monitoring is activated.

7. If necessary, disable group monitoring provisionally (see
2
Chapter 4.2.7 on Page 48).
8. Set up devices at the location of use.
3
Adding X-zone to a group
1. Position the ungrouped X-zone next to the main device.
2. Press key on the main device briefly.
Search run for the group devices is started.

Grouping LED main device: red-green flashing slowly.

Grouping LED for potential group devices: green

flashing slowly.
3. Press key on the required group device briefly.
X-zone included in group.

Grouping LED group device: lit in green.

4. Press key on the main device briefly.
Search run is terminated.

Grouping LED main device: lit in red-green.

Grouping is completed.

5. If necessary, disable group monitoring provisionally (see
Chapter 4.2.7 on Page 48).
6. Set up new group device at the location of use.
Establishing a wireless connection
49