Steba SousVide SV200 Mode D'emploi page 13

Before using for first time:
∙ The device must be properly cleaned before it is filled with water.
∙ Thoroughly clean container with hot water and a little washing up liquid Fill in and
let the pump run shortly, rinse and wipe dry.
∙ Attention! Do not immerse electrical part in water!
∙ Only wipe inside of lid with a damp cloth and dry.
Vacuum packing
Only use bags that are suitable for vacuum packing. There is no guarantee of proper
closure if normal bags are used. Ensure that there are no spices in the vicinity of the
weld seam, otherwise hermetic sealing will not be possible.
vacuum sealer VK5:
foil bag: 22 x 30cm:
foil bag: 28 x 40cm:
foil roll: 22 x 500cm:
foil roll: 28 x 500cm:
Setting the device
Installation
sensor needs a couple of minutes until he adjusted to the set temperature if pre-
heated water is filled in.
If there is no water in the pot, the device will not turn on and beeps E01.
Turn off the appliance, add water and start again.
The water level sensor switches off the appliance when the water level drops
rapidly
Art No 05-05-00
Art No 93-30-00
Art No 93-40-00
Art No 93-22-00
Art No 93-28-00
The appliance is suitable only for heating water, everything else
blocks the pump.
Pay attention, that the water together with the food reaches the
marking "max".
Plug in the device.
Turn on the "0/1" on the rear on the appliance.
If the water level is "min", E01 appears on the display and the
device beeps three times.
Water quantity
Do not put too much water in the device - leave sufficient room
for the food. If necessary, top up water until Max. The unit can be
switched on only when the water level reaches the max marking.
The food must always be covered with water. The temperature
EAN: 4011833301819
EAN: 4011833400574
EAN: 4011833400581
EAN: 4011833400550
EAN: 4011833400567
13