General Operation - Laserworld PL-5500RGB Outdoor Mode D'emploi

Manual: Laserworld PL-5500RGB Outdoor

7. General Operation

1. Power
Make sure that your device is provided with the correct voltage. Wrong voltage could lead
to irreparable damages. Please find the correct voltage data in the synoptical table at the
end of this manual. It must be ensured that the device is not directed to people or inflam-
mable objects during installation.
2. Turn on
a) Connect the RJ45 Interlock cable of the projector (as marked on the cable) to the RJ45 to
Sub-D adapter (included in delivery) and then to the Safety Unit (included in delivery).
Make sure that the key switch of the Safety Unit is set to „OFF".
b) Connect the power cable of the projector to a suitable power supply.
c) Turn the Safety Unit key switch to „ON".
3. Interlock
Laser output is only possible if the RJ45 Interlock cable is connected to the safety unit
(included in delivery).
4. Key switch
Laser output is only possible if the key (included in delivery) is connected to the key switch
and turned „ON".
5. Modes / Functions
The different operation modes can be selected with using the DIP switches inside the de-
vice. Any change of the operation mode requires a restart of the device (disconnect
power and reconnect it again). Do not change any DIP switch settings during operation.
Random and dangerous laser output can occur.
6. Turn off
To turn off the device, turn the key switch of the safety unit to „OFF" and disconnect the
laser from the power supply.
page 8 / 58
English