Laserworld PL-5500RGB Outdoor Mode D'emploi page 20

Manual: Laserworld PL-5500RGB Outdoor
d) ILDA Streaming
The Laserworld ShowNET interface is capable to act as range extender for ILDA signals by
transforming an incoming ILDA signal to a standard UDP network signal and transferring
this signal back to standard ILDA in a receiver unit (obviously another external ShowNET
interface is required as sender for this kind of application!) . Do NOT send the signal over
Wifi, this transmission method is not suitable in a professional environment.
Sender-Receiver configuration for ILDA over LAN, range extender use
The sender uses an IP address range between 192.168.2.70 and 192.168.2.85 and trans-
mits the signal to a receiver that has addresses in the range between 192.168.2.50 and
192.168.2.65. The specific IP addresses need to be set with DIP switches. Make sure there
are no other devices in the same network that use the same IP addresses.
Dip switch setting
switch 1
On (1) 0000 -> IP sender: 192.168.2.70 sends to 192.168.2.50
/ Off 0001 -> IP sender: 192.168.2.71 sends to 192.168.2.51
(0) 0010 -> IP sender: 192.168.2.72 sends to 192.168.2.52
0011 -> IP sender: 192.168.2.73 sends to 192.168.2.53
0100 -> IP sender: 192.168.2.74 sends to 192.168.2.54
0101-> IP sender: 192.168.2.75 sends to 192.168.2.55
0110 -> IP sender: 192.168.2.76 sends to 192.168.2.56
0111 -> IP sender: 192.168.2.77 sends to 192.168.2.57
1000 -> IP sender: 192.168.2.78 sends to 192.168.2.58
1001 -> IP sender: 192.168.2.79 sends to 192.168.2.59
1010 -> IP sender: 192.168.2.80 sends to 192.168.2.60
1011 -> IP sender: 192.168.2.81 sends to 192.168.2.61
1100 -> IP sender: 192.168.2.82 sends to 192.168.2.62
1101 -> IP sender: 192.168.2.83 sends to 192.168.2.63
1110 -> IP sender: 192.168.2.84 sends to 192.168.2.64
1111 -> IP sender: 192.168.2.85 sends to 192.168.2.65
Example:
Sender IP address setting:
switch 1
On (1) / Off (0) 0
This assigns IP address 192.168.2.71 to the Sender.
The corresponding receiver needs this IP address setting:
switch 1
On (1) / Off (0) 0
This assigns IP address 192.168.2.51 to the receiver.
The only difference between sender and receiver configuration is dip switch 5, which is 0 for the
sender and 1 for the receiver.
page 20 / 58
2 3
2 3 4
0 0 1
2 3 4
0 0 1
4 5
sender: 0
receiver: 1
5 6 7
0 0 1
5 6 7
1 0 1
English
6 7 8 9 10
0 1 1 0 0
8 9 10
1 0 0
8 9 10
1 0 0