Laserworld PL-5500RGB Outdoor Mode D'emploi page 12

Manual: Laserworld PL-5500RGB Outdoor
The stand alone mode allows for additional advanced features:
As standard, the stand alone mode cycles through the ILDA files on the SD cards and
plays the consecutively and in a general loop.
If DIP switch 4 is activated too, the stand alone mode only plays one specific ILDA file and
just loops this file.
switch 1
On (1) / Off (0) 0
Dip switch 1 can be used to step to the next file (just switch DIP switch 1 to on, then to
off again)
Dip switch 2 can be used to step to the previous file (just switch DIP switch 2 to on, then
to off again)
c) Demo Mode / Automatic Animation
switch 1
On (1) / Off (0) 0
In demo mode the ILDA files on the integrated SD card are triggered automatically. The
ILDA files are not only played back like in the stand alone mode, but they are also auto-
matically animated by ShowNET's internal intelligence. This creates dynamic animations,
even if only static frames are on the SD card.
This setting is especially suitable for demo purposes.
d) Master-Slave-Mode: Demo Mode
MASTER Unit:
switch 1
On (1) / Off (0) 0
SLAVE units:
switch 1
On (1) / Off (0) 0
To have the same effects show on all connected units, it is required to have the same
pattern sets on all SD cards inside the units.
page 12 / 58
2 3 4
0 0 1
2 3 4
0 0 0
2 3 4
0 0 0
2 3 4
0 0 0
5 6 7
0 1 0
5 6 7
1 0 0
5 6 7
0 1 0
5 6 7
0 1 1
English
8 9 10
1 0 0
8 9 10
0 1 0
8 9 10
0 1 0
8 9 10
1 0 0