General Operation - Laserworld Diode Série Mode D'emploi

Manual: Diode Series

8. General Operation

1. Power
Connect the power cable to the device and to the mains. Make sure that your device
is provided with the correct voltage. Wrong voltage could lead to irreparable damages.
Please find the correct voltage data in the technical datasheet. Make sure that the device
is not directed to people or inflammable objects during installation. To start the device,
connect the interlock bridge, insert the key and switch it on, and switch the device on.
The "Laser Emission" LED at the front side of the device begins to light up when the
device is ready for use.
2. Key Switch
There is a key switch at the back of the laser system. Please plug the key to the switch and
turn it on. The laser device only runs when the key is inserted and switched on. Prevent
misuse! Unplug the key when the laser is unattended to prevent misuse of the sys-
tem.
3. Fuse (only some models)
There is a fuse at the back side of the device. If the fuse should blow, please exchange
it with a new one. If the problems recurs, please contact your dealer or the Laserworld
service department.
4. Safety Presets
This device has an integrated Scan Safety (SFS). Is the Scan Safety active (on), single be-
ams are prevented. If the Scan Safety is switched off, it is possible to create full power
single beams - be careful!
Operating the laser system with disabled SFS may not be allowed in some countries.
Always ensure that maximum permissible exposure (MPE) is not exceeded in areas
accessible to the public or members of staff.
5. X / Y Inversion (only standard version with ShowNET mainboard)
Use the X, Y, and/or X/Y buttons to invert the beams resp. patterns on the x-axis and/or
y-axis.
6. Microphone Sensitivity (only standard version with ShowNET mainboard)
Adjust the microphone sensitivity with the ‚Sens' knob. This setting is needed for music
mode / sound sensitive operation.
7. Colors (not available for DS-1000RGB, DS-2000RGB FB4 nor DS-3000RGB FB4)
Use the ‚red' , ‚green' and ‚blue' knobs to control the intensity per output color channel.
8. Modes / Functions
The different operation modes can be selected using the DIP switches at the back of the
device. Any change of the operation mode requires a restart of the device (switch
the device off and on, or disconnect power and reconnect it again). Do not change any
DIP switch settings during operation. Random and dangerous laser output can occur.
page 6 / 8