Product And Package Contents; Preliminary Warning Notices; Initial Operations, Safety Instructions - Laserworld PL-5500RGB Outdoor Mode D'emploi

Manual: Laserworld PL-5500RGB Outdoor

1. Product and Package Contents

Please check if all listed parts are included and undamaged. Included in delivery:
1 x Laser projector
1 x Power cable
1 x Wall mount

2. Preliminary Warning Notices

1. Please use this device only according to these operating instructions.
2. Do not use the device if there are any visible damages on housing, connector panels,
power supplies or power cords.
3. This device must not be permanently connected to mains. Disconnect it from mains if
not in use.
4. Never look directly into the light source of a laser projector. Danger of damage to the
eyes or even blindness in extreme circumstances!
Any warranty claims are void if the warranty label is removed or tampered

3. Initial Operations, Safety Instructions

1. Make sure to use correct voltage; see in-
formation on device & in this manual.
2. Make sure that the device is not connec-
ted to mains during installation.
3. Installation has to be done by technical
experienced and qualified persons ac-
cording to safety regulations of the res-
pective country.
4. Always ensure that maximum permis-
sible exposure (MPE) is not exceeded
in areas accessible to the public or
members of staff.
5. In some countries an additional
pection by technical control institutes
could be necessary.
6. Connect an easily accessible inter-
lock connector or circuit breaker
to the projector.
7. The power supply should be easily acces-
sible.
page 5 / 58
1 x Safety unit with key
1 x Manual
1 x Adapter RJ45 to Sub-D
with in any way.
8. When installing the laser mount it with
9. For safe setup e.g. on walls or ceilings
10. If the device has been exposed to great
ins-
11. Never use dimmer, RC or other electroni-
1 x RJ45 Interlock cable
1 x RJ45 software cable
a minimum distance of 15 cm from walls
and objects.
please use a safety cord. The safety cord
should be able to withstand tenfold the
weight of the device. Please follow the
accident prevention regulations of pro-
fessional associations and/or comparable
regulations for accident prevention.
temperature changes, do not switch it
on immediately. Condensation (or any
moisture/water formed) may damage
this device.
cally switched sockets. Whenever possib-
le, do not use the laser projector together
with large appliances (especially fog ma-
chines) on the same mains!
English