Laserworld PL-5500RGB Outdoor Mode D'emploi page 13

Manual: Laserworld PL-5500RGB Outdoor
e) ArtNet Operation
IMPORTANT: ArtNet operation requires the show laser system to be connected in a DHCP
environment (router with integrated switch is recommended). The address handling
must be managed through DHCP. For questions on DHCP, please refer to 4.1. DHCP Mode.
Only ShowNET interfaces and the ArtNet controller must be used in the same network.
Avoid using other network devices in the same network.
Use the dip switches to assign a certain address:
switch 1
Binary DMX 1
channel offset
To activate ArtNet trigger, open the admin tool and navigate to the tab ‚Settings' . Then
change the ‚Data source for internal DMX effects' to ‚ArtNet input' as seen in the picture
below:
Click on ‚Store Data' to save the changes. Click on ‚OK' twice and wait until another win-
dow opens that asks to restart the ILDA interface. To do so, switch the laser system off
and on again.
ArtNet Modes
There are two ArtNet configuration modes:
(1) DJ Mode & (2) Professional Mode.
The DJ mode is more basic and comes with some pre-configured automations. It is sui-
table for most users.
The Professional mode comes with some advanced features and requires deper know-
ledge of ArtNet to be handled properly.
page 13 / 58
2 3 4 5
2 4 8 16
6 7 8 9
32 64 128 256
English
10
Switch 10 has to be ON (up)
for ArtNet operation