General Operation; Master-Slave - Laserworld BeamBar Serie Mode D'emploi

Manual: BeamBar Series

6. General Operation

1. Power
Connect the power cord to the device and to the mains. Make sure that your device is pro-
vided with the correct voltage. Wrong voltage could lead to irreparable damages. Please
find the correct voltage data in the synoptical table at the end of this manual. Make sure
that the device is not directed to people or inflammable objects during installation. To
start the device, connect the interlock bridge, insert the key and switch it on, and switch
the device on. The "Emission - Laser on" LED at the front side of the device begins to
light up when the device is ready for use.
2. Key Switch
There is a key switch at the back of the laser system. Please plug the key to the switch and
turn it on. The laser device only runs when the key is inserted and switched on. Prevent
misuse! Unplug the key when the laser is unattended to prevent misuse of the sys-
tem.
3. Modes / Functions
The different operation modes can be selected via the four buttons next to the „Set-
tings" display. „Menu" exits the current menu item and moves one level higher; „Enter"
confirms a selection or navigates to the selected menu item; „Up" / „Down" allows for
stepping through the current menu or to make a selection.
The BeamBar uses 13 DMX channels, so make sure that the next device uses an address
that doesn't overlap with this range.
3.1. SOUND-TO-LIGHT / AUTO
Sound-to-light operation allows to playback the integrated patterns to the beat of music or
any noises.
Select „ShΠd" by navigating with the „Menu" button and confirm with „Enter":
Standard selection is „SoUn", which means that beam will be triggered with the beat of
music:
Auto operation allows to random playback the internal patterns. They are played back accor-
ding to the internal system settings.
You can select „Auto" while „SoUn" is selected by navigating with the „Up" / „Down" buttons
and confirm with „Enter":
page 8 / 8
Microphone Sensitivity Settings
The sensitivity of the built-in microphone for the control of the sound-to-light operation can
be adjusted in the „SEnS" menu.
Select „SEnS" by navigating with the „Menu" button and confirm with „Enter":
The sensitivity can be adjusted between 1 and 100. Standard value is 50. Use the „Up" /
„Down" button to change the selection and confirm with „Enter".

3.2. MASTER-SLAVE

This laser is Master-Slave capable. This means that the Master laser system can hand on a
control signal to one or more Slave lasers, so all do the same.
Master-Slave only works with lasers of the same product series of the same product genera-
tion.
A: Link lasers with DMX cable
To use Master-Slave operation, link the Master with the Slave lasers with DMX cables. Make
sure to use the „DMX out" port on the Master and the „DMX in" on the Slave lasers. If several
Slave lasers are used, link the first one to the Master laser and daisy-chain the control signal
from the first Slave laser to the second etc..
B: Activate Master Laser
The Master laser needs to be set as control source.
Select „SLΠd" by navigating with the „Menu" button and confirm with „Enter":
Use the „Up" / „Down" buttons to navigate to „ΠASt" and confirm with „Enter":
C: Activate Slave lasers
Select „SLΠd" by navigating with the „Menu" button and confirm with „Enter":
Use the „Up" / „Down" buttons to navigate to „SLAu" and confirm with „Enter":
D: Set Sound-to-Light or Auto mode on Master laser
To use the Master-Slave operation: set the Master to either Sound-to-Light or Auto mode
(3.1.).
English English
Manual: BeamBar Series
page 9 / 10