General Operation - Laserworld Club Série Mode D'emploi

Manual: CS-500RGB KeyTEX

6. General Operation

1. Power
Connect your CS-500RGB KeyTEX with the external PSU and connect it to the mains. Ple-
ase make sure that you are using the correct voltage. False voltages could destroy the
device. Please use the voltage specified at the end of this manual. Don't aim the front of
the laser on people while installation.
2. Key Switch
Insert the key into the key switch on the back side of the laser and switch to "On" to switch
the device on or to "Off" to switch the device off. Please disconnect the device from the
power supply if you don't need it for a longer period.
3. Modes
Access the six different operating modes available in this product by using the MODE but-
ton on the front panel. Pressing and holding the MODE button for 2.5 seconds will turn
the product on or off. Press MODE to cycle through the modes. Please see a description
of each mode below.
Mode Description
Auto Built-in auto programs
Scene Pattern selection
Music Music mode
Clock Clock mode
Text Text mode
DMX DMX mode
This laser has also an ILDA IN port, which force-takes over control as soon as an ILDA in-
terface is connected to the laser.
page 8 / 27
4. IR remote controller
Button Function / Button
On/Off button
Auto mode
Sound mode
Pause
Pattern selection
Text mode
Clock mode
Numbers
Prev/Next
Mirror Effect
5. Using the keyboard
Use the keyboard to access menu options, select laser patterns, and enter different mo-
des. To use the keyboad with the laser, do the following:
1. Connect the USB cable of the keyboard to the USB interface on the back of the laser
projector.
2. Connect the laser to the mains.
Menu Options
To select the menu options using the keyboard, do the following:
1. Press
2. Use
TEXT and 6. DMX.
3. Press
English English
Description
Turns laser on/off
Laser runs in auto mode. Red LED indicator lights. Press the number
buttons to get different design patterns
Sound-active mode. Blue LED indicator flashes when sound is de-
tected. Sound-active mode displays the same design packs as auto
mode, but responds to sounds. Press and hold to enable sound
sensitivity adjustment. Use 1 (least sensitive) to 9 (most sensitive)
Pauses the program. Press again to continue the program
Press button to enter the pattern selection and select one of the
available patterns by pressing the number buttons.
Press to enter the text mode, then press any numbered button.
Enter text using the keyboard. Red and blue LED indicator lights.
Press numbers on the number pad to set the time and press ‚SPACE'
to start the clock function
Press to select a number
Press to go to a previous / next step
Press and hold to mirror the laser projection. Press repeatedly for up
to 4 mirrored options
to access the menu options. The laser output displays the current menu option.
to scroll through the menu options: 1. AUTO, 2. SCENE, 3. MUSIC, 4. CLOCK, 5.
to confirm the selection.
Manual: CS-500RGB KeyTEX
page 9 / 27