Laserworld PL-5500RGB Outdoor Mode D'emploi page 10

Manual: Laserworld PL-5500RGB Outdoor
SHOWCONTROLLER
(2)
suite
The integrated ShowNET mainboard fully supports the direct control of the laser via
Showcontroller as well. Showcontroller is a mightly software tool with many professional
features. It is very intuitive and thus easy to get started with, too.
The Software and a Demo Version can be downloaded on:
https://www.showcontroller.com
A license can be obtained from where this laser has been purchased.
3. Trigger ILDA files on the internal SD card and own effects
This laser system has an integrated memory (SD card) that can hold ILDA files with laser
frames and animations that can be triggered in different ways. It is possible to just use the
standard files that come with delivery or change the files to new, custom ones.
a) Upload own ILDA files to the integrated SD card
Besides the possibility to just upload *.ild files to the SD card with a standard card reader,
it is also possible to remotely load ILDA files to the integrated SD card via LAN without
having to open the device and extract the SD card from the mainboard.
To change the ILDA files, open the admin tool and select the tab ‚SD Card' as shown in the
picture below:
Select the folder with the ILDA files on the local hard drive by clicking on the button with
the three points on it:
IMPORTANT: Custom laser files have to be stored in *.ild format and must be named with
a number from ‚000.ild' to ‚255.ild' . Each number represents an ArtNet value on the res-
pective fader.
To upload *.ild files greater than 6 MB, please use an external card reader. Otherwise the
import may cause problems.
page 10 / 58
- professional laser show and multimedia control software
English