Tunturi Platinum PRO Mode D'emploi page 8

Console and Small Covers
• Plug the computer cable (31) and
hand pulse cables (38 x 2) into the
corresponding connectors on the
back of the console (30). Mount the
console on the upright tube with four
M5 x 12mm screws (119).
• Install the four moving handlebar
pivot covers (61, 62 left & 63, 64
right) with six 3.5mm x 12mm screws
(108).
8
Step 3:
• Install the four covers (57x2 & 58x2)
to the ends of the pedal tubes with
four M5 x 12mm screws (77) and four
3.5mm x 12mm screws (108) .
• NOTE! These covers can be installed
upside down!! There is an arrow on
the inside of each cover to indicate
correct installation direction.
• Install the four covers (59 & 60, 2
pcs each) at the connection point at
the bottom of the moving handlebars
using four 3.5mm x 12mm screws
(108) and four M5 x 12mm screws
(77). Install the front support tube
cover (51) with two M5 x 12mm
screws (77)
.