Tunturi Platinum PRO Mode D'emploi page 7

Step 2:
Upright tube and Moving Handlebars
1. Unravel the computer cable (31) and
snake it through the bottom of the
upright tube (12) and out the top.
Secure the upright tube to the main
frame with four M8 x 25mm bolts
(113). Mount the upright tube covers
(65 left & 67 right) and secure with
six M5mm x 12mm Phillips head
screws (77).
2. Install two M5 x 12mm Phillips head
screws (77) and two wave washers
(114) onto the upright tube axle and
then install the moving handlebars
O w n e r ' s m a n u a l
(10 left & 11 right) onto the axles. Do
not force them or use a hammer as
damage to the bearings can occur.
The moving handlebars have been
previously assembled at the factory
to assure the correct fit. Secure the
arms with two 3/8" x 3/4" Socket
hex head bolts (115) and 3/8" flat
washers (130). Attach the bottom
of the moving handlebars to the rod
ends of the pedal tubes using two
M10 x 38mm bolts (117) and M10
nyloc nuts (116).
3. Install the Bottle Holder (70) onto the
console mast with two M5x12mm
Phillips Head Screws (77).
•
P L A T I N U M P R O
GB
7