Door Opening/Closing (Where Provided); Reset The Remote Control - Palazzetti ECOMONOBLOCCO WT 16:9 3D N12 Manuel D'installation, D'utilisation Et De Maintenance

10 REMOTE CONTROL
(OPTIONAL)
10.1 Overview
This device allows you to remotely control the
operating parameters of the Ecomonoblocco.
10.2 Pairing at the control panel
Access the screen Info on the control panel dis-
play and navigate on the screen
Remote: scanning ...
Insert batteries in remote control (2 x AAA 1.5 V)
After few seconds the display will change screen,
you will be presented with the following infor-
mation and the remote control will be properly
paired to the control panel:
Remote: connected! Remote paired to the con-
trol panel
Temp [*C]: 26.0 Room temperature detected by
the remote control
Hu [perc]: 34.5 Percentage of humidity detected
by the remote control
Pr [mBar]: 1000 Atmospheric pressure detected
by the remote control
It may be necessary to perform this procedure
again in case the remote control remains outside
of the range of the signal for a long time.
10.3 Keys
1) Switch On / Off (press and hold for about 3 se-
conds to perform the desired operation)
2) Key momentarily not enabled
3) Power
4) Ventilation
5) Door opening (where provided)
6) Key momentarily not enabled
7) Keys to set the parameters
8) Keys to set the parameters
86
1
3
5
7
Fig. 38
10.4 Power adjustment (if applicable)
A) Press key 3 which will light up
B) Press button 7 or 8 to set the desired value.
10.5 Changing the ventilation
A) Press key 4 which will light up
B) Press button 7 or 8 to set the desired value.

10.6 Door opening/closing (where provided)

A) Press key 5 which will light up
B) Press button 7 or 8 to set the desired value.

10.7 Reset the remote control

If it is necessary to reset the remote control to
bring it back to the factory configuration, press
buttons 1 and 8 simultaneously for approximately
3 sec.
C 2
4
6
8
Fig. 39
004778670 - 11/02/2021