Keys; Power Adjustment (If Applicable); Changing The Ventilation - Palazzetti ECOMONOBLOCCO WT 16:9 3D N12 Manuel D'installation, D'utilisation Et De Maintenance

9.4.3 Operating parameters
The operation of the appliance is determined by
the of Power and Ventilation parameters set by
the user.
Power adjustment (for versions WT 16:9 3D
V12 EPLUS)
The power defines the quantity of combus-
tion air and therefore has a direct impact on
consumption.
To change the power:
A) Use the keys
or
menu
B) Modify the value with the keys
nimum, ... , 5 maximum)

Changing the ventilation

To change the value of the ventilation:
A) Use the keys
or
B) Modify the value with the keys
• "Off" = fan off
• "1" minimum, ... , "5" maximum
• "High" = ultra fast operation (to be used only
if it is necessary to quickly heat an environ-
ment)
• "Auto" = automatic operation (the appliance
will set the speed as a function of the temper-
ature of the combustion chamber
Door opening / closure (for versions WT 16:9 3D
V12 EPLUS)
To open / close the door:
A) Use the keys
or
menu
B) Press the key to open the door
C) Press the key
to close the door
Mode of operation of the control panel
The control panel is supplied with Access Point
configuration (AP Mode). In this mode it is pos-
sible to connect to the panel through the App to
check the device from your own smartphone.
004778670 - 11/02/2021
to go to the "Power"
(1 mi-
or
to go to the "Fan" menu
or
to go to the "Door"
ITALIANO
It is recommended to connect the control panel
to the home Wi-Fi network (through the smart-
phone app), in order that the control panel works
in Station Mode (Sta Mode).
Attention: in case of change of the router pass-
word, you will need to reset the control panel
according to the following procedure:
• Open the Info menu - screen 2 (as per the fig-
ure below):
connbox00xx
xxx.xxx.xx.x
signal xxdBm
proto DHCP
• Press the key of the control panel and hold it
for 4 seconds until you hear a "beep".
The control panel will then start the restart pro-
cess moving back to access-point mode.
You will now be able to log back in to the router
using the App (refer to the manual attached).
ENGLISH FRANÇAIS
Fig. 36
Fig. 37
85