Starting Up The Water Tap - Rösle Videro G4-SL Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

During the preparation stage ensure that your food is secured in the middle of the spit and balance it
on the grill using the weight. For whole chickens or turkeys, you should tie the legs or wings to the
body to avoid burning.
12. Position a catcher tray filled with liquid under the food in order to catch the juices.
13. Cook the meat with the lid closed according to the type of meat.
Observe the care notices on page 43.
Protection of the Primezone and Back Burner
The two burners are designed for a long life. However, some measures are necessary in order to avoid cracks
in the ceramic burner surfaces which may impair the function of the burner.
The ceramic burners must never come into direct contact with water. Hence why no water should be
poured onto the grill to extinguish flames. If the ceramics or the inside of a burner become wet when
the grill is switched off, the ceramics may break when the grill is used again due to the pressure of the
steam.
Keep cold water (rain, lawn sprinkler, garden hose, etc.) away from the ceramic burners.
If the ceramics are wet, remove the burners from the grill. Set down in reverse order so that the water
can run off. Allow them to fully dry indoors.
Never allow the ceramic burners to come into contact with or touch hard objects. Exercise caution when
removing and inserting the grate. If an object were to fall onto the ceramic surface, it would probably
crack it.
Significant temperature differences (winter barbecuing) may cause cracks in the ceramic surfaces.
There is a danger of oxygen deficiency in the case of poor ventilation, which causes flashbacks. If this
happens repeatedly, the ceramic surface cracks. This is why no more than 75% of the barbecuing area
should be covered with solid metal (i.e. by sheet metal or a large pan).
Damage arising due to noncompliance with these measures is not covered under the warranty.
Control knob lighting
The illuminated control knobs facilitate orientation at the control knob in poor lighting conditions.
• Insert the 4 AA batteries – 1.5 V into the battery compartment 14 inside the storage compartment.
• Open the doors on the front as shown in the diagram of the appliance overview on page 33. Ensure
correct polarity of each battery.
• Close the battery compartment lid.
• To switch on the lighting press button 16 (P. 33 ) on the operating panel.
• The lighting does not switch off automatically.

Starting up the water tap

• Read the safety and assembly notices on the separate supplementary sheet
from the manufacturer.
• The tap supplied has a ½" connection thread and is supplied with cold water.
• Screw on the ½" adapter for plug coupling A (not included in scope of sup-
ply). Ensure that the connection is screwed hand-tight and do not use a pliers
or spanner.
• Use a drinking water rubber hose with KTW approval for the water supply.
Cut off the water supply over the winter months and drain the tap and
hoses completely in order to avoid frost damage.
38
A

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Videro g4-sk

Table des Matières