Operation - Cleanmaxx T-110-80 Mode D'emploi

Operation

CAUTION!
❐ Never hold the nozzles close to parts of your body or animals during use and do not
place your hands inside the nozzles. They could become stuck to the device/injured.
If the vacuum cleaner should become stuck, switch the device off immediately.
❐ Switch on the device only when you have checked that all the parts have been
properly attached and that the dust container and the dust fi lter are correctly inserted.
❐ If the device switches itself off during use, it is possible that the overheating pro-
tection has been triggered. Switch off the device and check the nozzle for any blo-
ckages, remove them and then allow the device to cool down for at least 15 minutes
before you switch it on again. If this does not solve the problem, contact the custo-
mer service department.
❐ On no account should the device be used to suck up the following:
– Liquids or wet substances (e.g. wet carpet shampoo)
– Glowing ash, cigarette ends, matches, etc.
– Infl ammable or explosive substances
– Very fi ne dust (e.g. concrete dust), ash or toner
– Pointed, hard objects such as large pieces of broken glass
1. Make sure that the accessories are correctly attached to the device (see the "Before
Initial Use" chapter, "Inserting / Removing the Handle Pole" section and the "Atta-
ching Accessory Nozzles" chapter).
2. Unwind the mains cable. To unwind the mains cable quickly, turn the upper cable
winder down and pull off the mains cable.
3. Insert the mains plug into a properly installed mains socket that is easily accessible.
4. Mount the desired nozzle on the main unit as described in the chapter "Attaching
nozzles".
5. Press the On / Off switch to switch on the vacuum cleaner.
6. Guide the brush nozzle or the crevice nozzle over the surface to be cleaned.
7. Press the On / Off switch to switch off the vacuum cleaner.
8. If you have used the brush nozzle, move the device back into an upright standing
position.
9. Pull the mains plug out of the plug socket and wind the cable around the cable
winder.
10. If you have used the crevice nozzle (using as hand-held vacuum cleaner), remove it
and insert the handle pole back into the device.
11. Pull the mains plug out of the plug socket and wind the cable around the cable
winder.
12. To ensure optimum performance of the device, you should empty the dust container
and clean the dust fi lter regularly (see the "Cleaning the Device" chapter) after every
use.
20