Troubleshooting; Technical Data - Cleanmaxx T-110-80 Mode D'emploi

Troubleshooting

Should your device stop working properly at any time, exhibit signs of damage or require
a spare part, please contact the customer service department. For your own safety, do
not attempt to carry out repairs yourself. The following table contains tips on how you
can remedy small problems yourself.
Problem
The device
generates
suction.
The performance is
weak.
Dust escapes from
the device during
cleaning.
During vacuum
cleaning,
unpleasant smell is
detected.

Technical Data

Model number:
Article number:
Voltage supply:
Power:
Protection class:
Possible cause / solution / tips
• Is the plug not inserted in the mains socket correctly?
Insert the plug correctly.
• Is the plug socket defective? Try another mains socket.
no
• Check the fuse of your mains connection.
• Is the fi lter clogged? Clean the dust fi lter (see the "Cleaning
the Device" chapter).
• Is the dust container too full? Empty the container.
• Is the fi lter heavily clogged up? Clean the dust fi lter (see the
"Cleaning the Device" chapter).
• Is the nozzle being used clogged? Remove any objects
blocking the nozzle (see the "Cleaning the Device" chapter).
• Is the rotating brush of the brush nozzle dirty? Remove the
blockages.
• Is the dust container not closed correctly and / or not
(correctly) inserted into the device? Correct this.
• Is the
an A smell often develops when new devices are fi rst used.
The smell should disappear after you have used the device
several times.
device being
T-110-80
Z 09185
230 V~, 50 Hz
800 watts
II
23
used for the fi rst time?