System Reset - PERFECTPRO ROCKHART BT Mode D'emploi

System reset

If your radio fails to operate correctly, or some digits on the display
are missing or incomplete carry out the following procedure.
. Press the Standby button to switch on your radio.
2. Press and hold the Menu button until the Advanced menu of
current mode shows on the display.
3. Rotate the Tuning control until 'System ' appears on the display.
Then press the Tuning control to enter the setting.
4. Rotate the Tuning control until 'Factory reset' appears on the
display. Then press the Tuning control to enter the setting.
5. Rotate the Tuning control until 'Yes' is highlighted on the display
and press the Tuning control to confirm the setting. A full reset
will be performed. The station list and presets will be erased.
Sleep timer settings will be set to their default values. The display
will show 'Welcome to Digital Radio' and the unit will behave as
when first switched on.
If you do not wish to carry out a system reset, highlight 'No' and
then press the Tuning control. The display will revert back to the
previous display.
In case of malfunction due to electrostatic discharge, reset the
product using the above procedure. In some circumstances it may
be necessary to disconnect and then reconnect the mains power in
order to resume normal operation.
GB
4