PERFECTPRO ROCKHART BT Mode D'emploi page 24

Operating your radio-FM auto-tune
. Straighten up the antenna.
2. Press the Standby button to switch on your radio.
3. Press the Source button until the FM band is selected.
4. Rotate the Tuning control in a clockwise direction. The displayed
frequency will increase. Then press the Tuning control to carry
out an auto-tune. Your radio will scan up the FM band from the
currently displayed frequency and will stop scanning when it finds
a station of sufficient strength. To scan down in frequency, rotate
the Tuning control in an anticlockwise direction first and then
press the Tuning control. Your radio will scan down the FM band
from the currently displayed frequency and will stop scanning
when it finds a signal of sufficient strength.
5. After a few seconds the display will update. The display will show
the frequency of the signal found. If the signal is strong enough
and there is RDS data present then the radio may display the
station name.
6. To find other stations press the Auto tune button as before. When
the end of the waveband is reached, your radio will recommence
tuning from the opposite end of the waveband.
7. Adjust the Volume to the required setting.
8. To switch off your radio, press the Standby button.
Note:
If you find that FM reception is poor, try repositioning the antenna.
22