Software Version; System Reset; Backlight; Atp Passcode Lock - PERFECTPRO Handsfree 2 Mode D'emploi

SOFTWARE VERSION

The software display cannot be altered and is just for your reference. You can only view
the software version in DAB and FM mode.
Press the On/Off button to switch on the radio.
1.
2. Press the Source button to select FM or DAB mode.
3. Press the Menu button until the display shows "Full Scan", and then rotate the
Tuning knob until the display shows "System".
4. Press the Tuning knob; rotate the Tuning knob until the display shows "SW
version".
5. Press the Tuning knob to view the software version.
6. Press the Tuning knob to back to last menu and press menu to return to the
normal radio display.
Note: Software upgrade should be done by qualified service personnel.

SYSTEM RESET

If the radio fails to operate correctly, or some digits on the display are missing or
incomplete, carry out the following procedure.
1. Press the On/Off button to switch on the radio.
2. Press the Menu button,
3. Rotate the Tuning knob until the display shows "System". Press the Tuning knob.
4. Rotate the Tuning knob until the display shows "Factory reset". Press the Tuning
knob.
5. Rotate the Tuning knob to select between "Yes" or "No". Select "Yes" if you wish to
reset the radio, otherwise, select "No".
6. Press the Tuning knob to cause the factory reset.
7. A full reset will be performed. All presets and the station list will be erased. All
settings will be set to the default values. The display will show "Restarting" for a
few seconds, and then the radio will automatically perform an auto scan of the Band
III DAB channels and the FM band, the display will show "Scanning" at DAB and
"Auto" at FM.
In case of malfunction due to electrostatic discharge; reset the product as above to
resume normal operation. If you are not able to perform the reset operation as above,
remove and reconnect all batteries and the power supply.
"Under the environment with Conducted Immunity disturbance / Radiated Immunity, the
sample may malfunction. It will automatically recover to normal when the Conducted
Immunity disturbance / Radiated Immunity stopped."
21

BACKLIGHT

LCD backlight configuration
1. Press the On/Off button to turn on the radio.
2. Press the Menu button, and then rotate the Tuning knob until the display shows
"System".
Press the Tuning knob; rotate the Tuning knob until the display shows "LCD
3.
backlight".
4. Press the Tuning knob to enter the LCD backlight adjustment menu.
5. Rotate the Tuning knob to select "on" in order to keep backlight always lightened
when the radio is turned on with AC power supply;
6. Or rotate the Tuning knob to select "off" (by default) so that the backlight will be
lightened for about 10 seconds whenever a button is pressed with AC power
supply.
7. Press the Tuning knob to confirm your choice.
Note: The LCD backlight option "on" is only functional when the radio is powered
by AC power supply. When the radio is powered by battery power supply, the
LCD backlight is switched to option "off" – 10 seconds lightened when a button is
pressed. When the radio is connected to mains AC power again, the last user
setting will be applied again.
ATP PASSCODE
This radio is equipped with an Anti-Theft-Protection system (ATP system). When the
ATP system is enabled, a passcode is required for turning on the radio.
1. Press the On/Off button to turn on the radio.
2. Press the Menu button.
3. Rotate the Tuning knob until the display shows "System". Press the Tuning knob.
4. Rotate the Tuning knob until the display shows "Passcode". Press the Tuning
knob. "Enable" or "Disable" will be displayed, to enable ATP, turn and press Tuning
knob to select "Enable".
5. "Change Passcode" will be displayed, enter a 4-digits numeric passcode by
pressing the preset buttons (1-10)
6. "Confirm Passcode" will be displayed. Enter a second time the same passcode to
confirm.
7. To disable passcode, select "Disable" as previously showed. And re-enter the
previous passcode to disable the lock.
When ATP is enabled, and if wrong passcode is entered for three times, a timer will be
activated. The next attempt will be possible only after the timer has elapsed. The timer
period will be increased with further wrong passcodes.
WARNING: If you choose to activate the passcode, please note your passcode
somewhere safe as a memory back-up in case you should forget it. This is
strongly advised, as there is no way to reset the radio should the passcode be
forgotten!
GB
GB
22