Battery Resistance Meter; Battery Storage; Save Data Program - Multiplex HiTEC X2-700 Multi-Charger Mode D'emploi

Hochleistungs Profi Balance
LADER / ENTLADER

11. Battery Resistance Meter

BATT/PROGRAM
BATT RESISTANCE
1:5m
3:3m
5:3m

12. Battery Storage

For your convenience, the X2-700 has a data storage and
load program that can store up to ten preset battery charge
or discharge confi gurations per channel. You can recall these
settings when charging or discharging without having to
setup the program again.

13. Save Data Program

[ BATT MEMORY 1 ]
ENTER SET ->
Start/Enter
SAVE [01] NiMH
14.4V 3000mAh
Voltage Data Number Capacity Type of Battery
Batt Type Stop Start/Enter > 3 seconds
NiMH CHARGE At
CUR LIMIT 5.0A
– +
DEC INC
NiMH DICHARGE
1.0A 11.0V
48
Start
Enter
2:4m
4:4m
INC
6:4m
– +
DEC INC
Professional Balance Charger, Discharger
The user can check each cell's resistance. Please connect
the battery to the charger main battery lead to battery
socket and balance wires to balance socket.
Press the „START/ENTER" to enter the Lithium
Battery Resistance program.
The screen indicate each cell's resistance.
To get to the save data screen press the „BATT. TYPE/STOP"
button until you see the Save Data screen. Press the
„START/ENTER" key to modify the menu, and use the
„INC" or „DEC" to change the parameters.
Setting of the parameters in the fi rst screen will not affect
the charge and discharge process. It is only for identifying
the specifi cation of the battery you will create a preset for.
In this example it is a NiMH battery pack with 12 cells and
a capacity of 3000mAh. When you have completed this
process press and hold the „START/ENTER" key for 3
seconds to enter the charge/discharge setup screen.
Set up the charge current in the manual mode, or the current
limit in the auto mode. Press the „INC" and „DEC" key
simultaneously to make the current fi eld blink to switch the
charge mode.
Set up the discharge current and cutoff voltage.