Multiplex HiTEC X2-700 Multi-Charger Mode D'emploi page 31

Professional Balance Charger, Discharger
Discharging
The main purpose of discharging a battery is to clean the
residual capacity of the battery or to reduce the battery's
voltage to a defi ned level. It is even more critical that close
attention be paid to the discharging process as failure to
properly monitor the process can destroy your battery. The
fi nal discharge voltage should be set correctly to avoid deep
discharging. Some rechargeable batteries have a memory
effect. If they are partly used and recharged before the
Discharging Lithium Batteries
Lithium batteries cannot be discharged to a voltage lower
than the minimum voltage for the cell type. Doing so will
result in a rapid loss of capacity and/or total failure. While
the X2-700 monitors each individual cell during the
discharge process the discharging cutoff is based on the
total pack voltage.
This charger was designed and approved exclusively for use with the types of batteries stated in this instruction
manual. MULTIPLEX Modellsport GmbH accepts no liability of any kind if the charger is used for any purpose
other than that stated. Since we are unable to assure that the user will properly follow the supplied instruc-
tions and have no control over one's proper use or maintenance of the device, we are obligated to deny any
and all claims of liability for loss, damage or injury which are incurred due to improper use and operation of
this product. Unless otherwise prescribed by law, the limit of our liability shall not exceed the invoice value of
the charger.
Hochleistungs Profi Balance
LADER / ENTLADER
complete charge/discharge cycle is accomplished, they
remember this and will only use that part of their capacity
next time. It is generally known that NiCd and NiMH batteries
suffer from this memory effect.
Generally, lithium batteries don't need to be discharged
and it is not recommended that you discharge them. If you
do choose to discharge your lithium batteries make sure
to pay attention to the minimum voltage setting as well as
the individual cell voltage.
31