Multiplex HiTEC X2-700 Multi-Charger Mode D'emploi page 43

Professional Balance Charger, Discharger
Charging Lithium Battery in Balance Mode
This function is for balancing the voltage of Lithium-polymer
battery cells individually while charging. In the balance mode,
the battery needs to have a balance lead to connect to the
balance port at the right side of the charger and the battery's
power leads to the output of the charger.
– +
DEC INC
Batt type
stop
Number Charging
of Cells Time
FAST CHG
– +
DEC INC
Batt type
stop
Number Charging
of Cells Time
When charging lithium chemistry batteries in the fast charge
mode the charging current will become lower towards the
end of the charge cycle. In fast mode the charging capacity
is slightly lower than in normal charge mode, but charging
time is reduced.
– +
DEC INC
Start
> 3 seconds
Enter
Start
Enter
Battery
Voltage
Charging Charged
Current
Capacity
– +
DEC INC
Start
> 3 seconds
Enter
Start
Enter
Battery
Voltage
Charging
Charged
Current Capacity
Hochleistungs Profi Balance
LADER / ENTLADER
Charging in this mode is different from the normal modes
because the built-in processor monitors the voltage of each
individual cell and controls the input current fed into each
cell in order to equalize the voltage.
The fi rst line on the left side of this screen shows the type of
battery chosen. The second line shows the user set current
on the left and the user set voltage on the right. After setting
the current and voltage, press the „START/ENTER" key for
more than 3 seconds to start the process.
The next display shows the number of cells you set up as „R"
and the number of cells the processor detects as „S". If both
numbers are identical, you can start charging by pressing the
„START/ENTER" button. If not, press the „BATT TYPE/STOP"
button to go back to the previous screen to carefully check
the number of cells of the battery pack before proceeding.
This next screen shows the real-time status during the charge
process. Press the „BATT TYPE/STOP" key once to stop
the charge process.
Charging Lithium Batteries in Fast Mode
The fi rst line on the left side of this screen shows the type of
battery chosen. The second line shows the user set current on
the left and the user set voltage on the rights. After setting
the current and voltage, press the „START/ENTER" key for
more than 3 seconds to start the process.
The next display shows the number of cells you set up as
"R" and the number of cells the processor detects as "S".
If both numbers are identical, you can start charging by
pressing the „START/ENTER" button. If not, press the
„BATT TYPE/STOP" button to go back to the previous
screen to carefully check the number of cells of the battery
pack before proceeding.
This next screen shows the real-time status during the charge
process. Press the „BATT TYPE/STOP" key once to stop the
charge process.
43