ORIGINAL INSTRUCTIONS
READ MANUAL BEFORE USE
Component
Charging Lead
Brushes
Squeegee Blade
Filters
Tanks
As with all electrical equipment care and attention must be exercised at all times during its use, in addition
to ensuring that routine and preventative maintenance is carried out periodically in order to ensure its safe
operation.
WARNING
Failure to carry out maintenance as necessary, including the replacement of parts to the correct standard
could render this equipment unsafe and the manufacturer can accept no responsibility or liability in this respect.
When ordering spare parts always quote the Model Number / Serial Number specified on the Rating Plate.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
If this product does not have a factory installed Numatic battery charger and batteries then it is the responsibility of
the owner and user of the product to ensure that the charging system and battery combination are compatible, fit for
purpose and safe to use.
This machine is not suitable for picking-up hazardous dust.
Do not use on surfaces having a gradient exceeding that marked on the appliance.
The machine is not to be stored outdoors in wet conditions.
This machine is for indoor use only.
CAUTION
Read the instruction manual before using the appliance.
This product meets the requirements of IEC 60335-2-72
NOTES
This machine is also suitable for commercial use, for example in hotels, schools, hospitals, factories, shops and
offices for other than normal housekeeping purposes.
•
Ensure only competent persons unpack/assemble the machine.
•
Keep your machine clean.
•
Keep your brushes in good condition.
•
Replace any worn or damaged parts immediately.
DO
•
Regularly examine the power cord for damage, such as cracking or ageing. If damage is found, replace the
cord before further use.
•
Only replace the power cord with the correct Numatic approved replacement parts.
•
Ensure that the work area is clear of obstructions and / or people.
•
Ensure that the working area is well illuminated.
•
Pre-sweep the area to be cleaned.
•
Use steam cleaners or pressure washers to clean the machine or use in the rain.
•
Attempt machine maintenance or cleaning unless the power plug has been removed from the supply outlet.
•
Allow any inexperienced repairs. Call the experts.
•
Strain cable or try to unplug by pulling on cable.
DON'T
•
Leave the brush pad on the machine when not in use.
•
Allow the machine to be used by inexperienced or unauthorised operators or without appropriate training.
•
Use the machine without the solution tanks properly positioned on the machine, as shown in the instructions.
•
Expect the machine to provide trouble-free, reliable operation unless maintained correctly.
•
Lift or pull the machine by any of the operating triggers - Use the main handle.
•
Remove the handle from the machine except for service and repair.
•
Use on surfaces having a gradient exceeding that marked on the machine.
Information for Scrubber Dryer
Interval
DAILY
DAILY
BEFORE EACH USE
BEFORE EACH USE
AFTER EACH USE
Scuffing, cracks, splits, conductors showing
9
Inspect for
Bristle damage, wear, drive collar wear
Wear, cracks, splits
Clogging and debris retention
Rinse dirty water tank after use