Removing / Inserting The Battery; Switching On; Checking The Chain Brake; Checking The Oil Automatic System - Grizzly AKS 2440 Lion Traduction De La Notice D'utilisation Originale

Removing / inserting the battery

1. To remove the battery (19) from
F
the appliance, press the release
button (19a) on the battery and
pull out the battery.
2. To insert the battery (19), place
it on the guide track (17) and
push it back into the appliance.
It will audibly snap in.

Switching on

1. Check before the start, whether
G
sufficient chain oil is in the tank
and, if necessary, refill with
chain oil (see Chapter Operation
Start).
2. Release the chain brake, where
you shift the brake arm (3) back
against the front grip (8).
3. Hold the chainsaw firmly with
both hands, with the right hand
on the rear grip (1) and the left
hand on the front handle (8).
Thumb and finger must close
securely over the handles.
4. For switching on, activate the
switch-on block (11) with the
right thumb and then press the
On/Off switch (10), the chain-
saw runs with highest speed.
Release the switch-on block
again.
5. The power saw switches off
when you release the On/Off
switch (10) again. Switching for
continuous running is not pos-
sible.

Checking the chain brake

The motor cannot be turned on
if the chain brake has engaged.
Do not employ the chain brake in
order to start the chainsaw or to
switch it off.
1. Place the chainsaw onto a solid,
H
flat surface. It must not contact
any objects.
2. Release the chain brake by
shifting the brake arm (3) over
against the front grip (8).
3. Hold the chainsaw firmly with
both hands, with the right hand
on the rear handle
left hand on the front handle (
8). Thumb and finger must close
securely over the handles.
4. Turn on the chainsaw.
5. Activate the chain braking lever
(3), with running motor, with the
left hand. Chain should stop
abruptly.
6. Once the chain brake is work-
ing properly, release the on/off
switch (10) and the chain brake.
If the chain brake does not func-
tion correctly, you must not use
the chainsaw. A slack saw chain
leads to danger of injury. Return
the chainsaw to our Service-
Center for repair.
Checking the oil automatic
system
Check the oil level and the automatic oil
system before commencement of work.
• Switch on the chainsaw and hold it
above a bright background. The saw
must not touch the ground.
If an oil trace can be seen, the chainsaw
is working trouble-free.
GB
( 1) and the
G
G
151