Chain Lubrication; Charging The Battery - Grizzly AKS 2440 Lion Traduction De La Notice D'utilisation Originale

chain brake lever (3) is pulled up
against the front grip (8).
2. Unscrew the fastening bolt (14).
3. To tighten the saw, turn the chain
adjustment ring (13) clockwise.
To loosen the tension, turn the
chain adjustment ring anti-clock-
wise.
4. Tighten up the fastening bolt (14)
again.
With a new saw chain, you must
readjust the chain tension after at
least 5 cutting operations.

Chain lubrication

The rail and chain must never be
without oil. If you operate the elec-
tric chainsaw with too little oil, the
cutting performance and the life-
time of the saw chain is reduced,
since the chain becomes blunt
faster. You can identify a case of
too little oil where smoke develop-
ment or discoloration of the rail oc-
curs.
The chainsaw is equipped with an auto-
matic oiling system. As soon as the motor
is speeded up, the oil also flows faster to
the chain bar (4).
Filling up with chain oil:
• Check the oil fill level and regularly top
up with oil ( 25).
• Use Parkside bio-oil; this product con-
tains additives that reduce wear and
tear and does not damage the pump
system. bio-oil is available from our
Service-Center.
• If you have no Grizzly bio-oil available,
use chain lubrication oil with low adhe-
sive additive content.
1. Unscrew the oil fill cap (2) and fill
D
up with chain oil.
2. Wipe off any spilled oil and close
the cap again.
Always switch off the device and
allow the motor to cool before
filling with chain oil. There is a
risk of fire if oil overflows.

Charging the battery

It is recommended that the device
be used with a 24 V battery (4 Ah.
Do not expose the battery to
extreme conditions such as heat
or impact. Risk of injury from
escaping electrolytic solution!
After eye/skin contact, rinse the
affected areas with water or a
neutraliser and consult a doctor.
Charge the battery in a dry room
only.
Prior to attaching the charger,
check that the battery's outer sur-
face is clean and dry.
There is a risk of injury due to elec-
tric shock.
Only use the original charger from
the package to charge the battery.
Mind not to charge the appliance
for more than 8 hours at a time. If
you do, the battery and the appli-
ance may be damaged and longer
charging times would be a waste
of energy. Excessive charging will
void the warranty.
• Charge the battery before the first
time of use. Do not briefly charge
the battery several time in a row.
GB
149