The Fi Rst Time You Use The Heater - Tylo AIR Notice D'utilisation

4
GENERAL INFORMATION
Congratulations on your new sauna heater! Follow this user guide
to get the most from your product.
Wet and dry saunas are forms of bathing which have a long-
standing tradition. These saunas are best enjoyed when heated
to temperatures between 70-90°C.
PRIOR TO USE
The fi rst time you use the heater
Pull off the protective plastic on the exterior of the sauna heater,
see Figure 1.
1
Figure 1: Pull off the protective plastic.
Fill the stone compartment.
Note! Always use dolerite stones (Tylö Sauna
Stones)! "Ordinary" stones may damage the heater.
Do not use ceramic stones! Ceramic stones may
damage the heater. The heater guarantee does not
cover damage caused by ceramic stones.
Do not use the heater until the stone compartment is well-fi lled.
Fill the stone compartment around the heating elements from
the bottom to the top, to approx. 50 mm above the top front edge.
Do not press the stones into place. Capacity: Approx. 100 kg of
stones.
Place the stones loosely to allow optimum air circulation.
The heating pipe elements must neither be squeezed together
nor against the side.
The sauna stones:
• must tolerate extreme heat and fl uctuations caused by water
being poured on them.
• must be cleaned before use.
• must have an uneven surface, so that the water "clings" to
the stone surface and evaporates effi ciently.
• must be between 60-150 mm in size to allow air circulation
in the stone compartment. This will extend the life of the pipe
elements.
2
Figure 2: Filling the stone compartment
1.
Min.
Important!
30 mm
Min.
30 mm
Min.
30 mm
Stone compartment
1
Min.
30 mm
Min.
30 mm
Min.
30 mm