Leica DMIL Mode D'emploi page 28

Positioning the IMC slit diaphragm slide* on
the transmitted-light illumination carrier
!
Attention!
The condensor slide is not protected against
inadvertent sliding out.
• Remove the blank slide if present.
• Hold the condensor slide so that the lettering
"Top left" is located on the left upper side
(29.1) and the other lettering points forward.
The catches (29.2) are located on the upper
long side of the slide and point toward the
centre of the specimen stage.
• Insert the condenser slide into the trans-
mitted-light illumination carrier from the side
(30.1). The keyways should click in place
when the slide is inserted.
Fig. 29 IMC slit diaphragm slide and IMC modulator
1 Lettering "Top left" on condenser slide, 2 Catches, 3 Letter-
ing on IMC modulator
1
3
28
2
3
Positioning the IMC modulator*
• Remove the blank slide if present.
• Insert the IMC modulator so that the lettering
(29.3) points forward.
• Lock the slide in position BF (lettering BF is
visible) or in position IMC (lettering IMC is
visible).
Fig. 30
1 Holder for IMC modulator
1