Prepare Dishwasher - Maytag W10290309A Instructions D'installation

Prepare Dishwasher

Tip Over Hazard
Do not use dishwasher until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
1
Attach insulation
Tabs
Using the precut slots in the insulation, fasten the insulation over the
molded hooks on the tub. Be sure to fasten the insulation down on
both sides of the tub.
2 Put dishwasher on its back
Helpful Tip: Place cardboard under dishwasher until installed in
cabinet opening to avoid damaging floor covering. Do not use door
panel as a worktable without first covering with a towel to avoid
scratching the door panel.
Using two or more people, grasp sides of dishwasher door frame and
place dishwasher on its back.
10
3
Using a ¹⁄₄" hex head socket, nut driver or Phillips screwdriver,
remove the 2 screws attaching access panel and lower panel to
dishwasher.
NOTE: Do not remove tech sheet from access panel.
4
Completed
Install
Using a ¹⁄₄" hex head socket, nut driver or Phillips screwdriver,
remove terminal box cover. Retain for later use.
5
Install a UL Listed/CSA Approved strain relief. Make sure screw
heads are facing to the left when tightening conduit nut. Strain
relief may be provided with the power supply cord kit.
Remove panels
Remove terminal box cover
Install strain relief