Install Drain Hose - Maytag W10290309A Instructions D'installation

Route water supply line
3
Slowly route water supply line through hole in cabinet. (If using
copper tubing, it will bend and kink easily, so be gentle.) It
should be far enough into the cabinet opening to connect it to
the dishwasher inlet on the front left side of the dishwasher.
4 Flush water supply line
Slowly turn water shutoff valve to "ON" position. Flush water
into a shallow pan until clear to get rid of particles that could
clog the inlet valve. Turn shutoff valve to "OFF" position.
5
Slide nut and ferrule
onto tubing
Copper tubing only: Slide nut, then ferrule, about 1"
(2.5 cm) onto copper tubing.
NOTE: To avoid vibration during operation, route the
water supply line so that it does not touch the
dishwasher base, frame or motor.
8
Add 90° elbow fitting to the
6
water supply line
Connect the ³⁄₈" compression fitting to the water supply
line prior to installing the unit into the cabinet opening.
Attach such that the ³⁄₄" connection is facing upward.
Copper tubing only: Put the tubing into the 90° elbow
fitting as far as it will go (the copper tubing bends and
kinks easily). Slide the nut and ferrule forward and start
the nut onto the elbow threads.
Flexible braided connection: Secure nut to elbow using
⁵⁄₈" open ended wrench or adjustable wrench.
NOTE: Do not use Teflon
fittings.

Install Drain Hose

IMPORTANT: Always use a new drain hose. Check local codes
to determine whether an air gap is required.
1 Drill hole
If needed, drill a 1¹⁄₂" (3.8 cm) diameter hole in cabinet wall or side
of the opening closest to the sink.
Nut
2 Route drain hose
Ferrule
Route drain hose as shown through hole in cabinet to the front
center of opening where drain connection will be made. Tape
drain hose to the floor in area shown. This will keep the drain hose
from moving when dishwasher is moved into cabinet opening.
† TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.
®† tape with compression
1¹⁄₂
(3.8 cm)
Drain hose
"