Move Dishwasher Into Cabinet Opening; Move Dishwasher Close To Cabinet Opening - Maytag W10290309A Instructions D'installation

Option 3, Dishwasher with Plastic Tub Side Attachment
(for marble, granite or other hard surface countertops)
Order Mounting Bracket Kit Part Number 8212560.
Move Dishwasher into Cabinet
Opening
1 Stand dishwasher upright
Using two or more people, stand dishwasher upright.
NOTE: Do not install kickplate until instructed to do so.
2 Move dishwasher close to
cabinet opening
IMPORTANT: Double-check correct placement
of utilities. Grasp the sides of the dishwasher at the edges of the
door panel. Tilt dishwasher backward on wheels and move
dishwasher close to cabinet opening.
NOTE: Do not push on the front of the panel or on the console–
they may dent.
Helpful Tip: Temporarily tape utilities to the floor in the
locations shown to keep them from moving when dishwasher is
moved into the cabinet opening.
3
Check water and drain
hose position
Check that water line is on the left side of opening
and drain hose is near the center of the cabinet opening.
14
Water
line
Direct Wire
Only
Drain
hose
Cable
4 Open and close door
With another person holding the dishwasher to keep it from
tipping, open and close the door a few times. If the door closes
or falls open under its own weight, the door tension will need to
be adjusted.
5
Closes too quickly—
Decrease spring tension
If the door closes too quickly, decrease the spring tension by
moving the spring end toward the front of the dishwasher.
NOTE: Springs should be in the same notches on left and right
sides.
6
Door falls open—
Increase spring tension