Drain Requirements; Water Supply Requirements; Electrical Requirements - Maytag W10290309A Instructions D'installation

Drain Requirements

• A new drain hose is supplied with your dishwasher.
If the drain hose is not long enough, use a new drain hose with a
maximum length of 12' (3.7 m) (Part Number 3385556) that
meets all current AHAM/IAPMO test standards, is resistant to
heat and detergent, and fits the 1" (2.5 cm) drain connector of the
dishwasher.
• Make sure to connect drain hose to waste tee or disposer inlet
above drain trap in house plumbing and 20" (50.8 cm) minimum
above the floor. It is recommended that the drain hose either be
looped up and securely fastened to the underside of the counter,
or be connected to an air gap.
• Make sure to use an air gap if the drain hose is connected to
house plumbing lower than 20" (50.8 cm) above subfloor or floor.
Use of air gap
• Use ¹⁄₂" minimum I.D. drain line fittings.
• If required, the air gap should be installed in accordance
with the air gap installation instructions. When connecting the air
gap, a rubber hose (not provided) will be needed to connect to the
waste tee or disposer inlet.

Water Supply Requirements

• A hot water line with 20-120 psi (138-862 kPa) water
pressure can be verified by a licensed plumber.
•120°F (49°C) water at dishwasher.
• ³⁄₈" O.D. copper tubing with compression fitting or
flexible braided water supply line (Part Number 4396897RP)
NOTE: ¹⁄₂" minimum plastic tubing is not recommended.
• A 90° elbow with ³⁄₈" N.P.T. external pipe threads on one
end.
• Do not solder within 6" (15.2 cm) of the water inlet valve.
Air gap

Electrical Requirements

Be sure that the electrical connection and wire size are adequate
and in conformance with the National Electrical Code, ANSI/NFPA
70 - latest edition and all local codes and ordinances.
A copy of the above code standards can be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02169
You must have:
• 120-volt, 60 Hz, AC-only, 15- or 20- amp, fused electrical
supply.
• copper wire only.
We recommend:
• a time-delay fuse or circuit breaker.
• a separate circuit.
If connecting dishwasher
with a power supply cord:
• Use UL listed power supply
cord kit (Part Number 4317824)
marked for use with dishwasher.
• Power supply cord must plug into
a grounded 3 prong outlet, located in the
cabinet next to the dishwasher opening.
Outlet must meet all local codes and
ordinances.
If connecting dishwasher with direct wiring:
• Use flexible, armored or
nonmetallic sheathed,
copper wire with
grounding wire that meets
the wiring requirements for your home and local codes and
ordinances.
• Use a UL Listed/CSA Approved strain relief.
5