Prepare Dishwasher; Remove Access Panel; Disconnect And Remove Drip Pan Assembly - Maytag MDB7959SKZ Manuel De L'utilisateur

PREPARE DISHWASHER

WARNING
Tip Over Hazard
Do not use dishwasher until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
8.
Put the dishwasher on its back
Helpful Tip: Place cardboard under dishwasher until installed
in cabinet opening to avoid damaging floor covering.
Using two or more people, grasp sides of dishwasher door frame,
and place the dishwasher on its back.
Do not use the door panel as a worktable without first covering
it with a towel to avoid scratching the door panel.

REMOVE ACCESS PANEL

9.
Remove access panel
Using a 5/16" (7.9 mm) nut driver or Phillips screwdriver, remove
the two screws attaching access panel to dishwasher. Once the
screws are removed push the access panel toward the top of the
project to unhook it and then remove it.
DISCONNECT AND REMOVE DRIP PAN
ASSEMBLY
10a.
Remove drip pan assembly
Drip pan assembly
To remove the drip pan assembly, press the snap at each side
of the plastic tray in toward the center of the product and pull
toward yourself. Take caution not to pull too far or too hard as the
float switch wire is still connected at this time.
10b. Remove float switch wire
To remove the float switch wire, gently depress the connector
latch tab (1) and then pull the connector (2) out of the housing.
The float itself should not be removed from the tray.
15