Prepare And Route Water Line - Maytag W10290309A Instructions D'installation

Power Supply Cord–Prepare hole
2
Wood
cabinet
Wood cabinet: Sand the hole until smooth.
Metal cabinet: Cover hole with grommet (Part Number 302797)
included with power supply cord kit.
Option B, Direct Wire:
Helpful Tip: Wiring the dishwasher will be easier if you route the
cable into the cabinet opening from the right-hand side.
1 Direct Wire — Drill hole
Optional location
(1.9 cm)
Drill a ³⁄₄" (1.9 cm) hole in right-hand cabinet side or rear.
See product and cabinet opening dimensions.
Direct Wire–Prepare hole
2
Wood
cabinet
Wood cabinet: Sand the hole until smooth.
Metal cabinet: Cover hole with grommet (Part Number 302797
not included)
Metal
cabinet
Preferred location Preferred l o cation Preferred l o cation
Metal
cabinet
Direct Wire–Route cable
3
Route cable from power supply through cabinet hole (cable must
extend to the right front side of cabinet opening).
Tape cable to the floor in area shown. This will keep cable from
moving when dishwasher is moved into cabinet opening.

Prepare and Route Water Line

Helpful Tip: Routing the water line through the left side of
cabinet opening will make water connection easier.
Drill hole
1
Preferred locations Preferred loc ations Preferred loc ations
¹⁄₂
"
(1.3 cm)
Drill a ¹⁄₂" (1.3 cm) hole in the cabinet side or rear.
Measure water supply line
2
Measure overall length of copper tubing or flexible braided
water supply line. Attach to the hot water line using a
connection configuration that is in compliance with local codes
and ordinances. The water line to the dishwasher should have a
manual shutoff valve.
Optional locations Optional loc ations Optional loc ations
Hot water line
7