Ethernet Adapter and not the telephone cord provided
with the Communicator.
3. Insert the standard (narrow) end of the USB cable
(included with the USB Ethernet Adapter) into one
of the USB ports on the Communicator labeled
.
4. Insert the square end of the USB cable into the
end of the USB Ethernet Adapter nearest the
adapter light.
5. Insert the Ethernet cable (included with the USB
Ethernet Adapter) into the opposite end of the
adapter.
6. Plug the Ethernet cable into an Ethernet port for
your internet service, such as a modem, router, or
Ethernet wall jack.
• The USB Ethernet Adapter is properly
connected if the green light in front is lit (solid or
flashing).
7. When the Heart button flashes, press it.
• Your Communicator's wave lights will flash
green in sequence and repeat for several
minutes as shown in "Using the Heart Button"
on page 30
• If you have previously completed initial setup,
the Heart button will not flash at this point.
8. Your Communicator has successfully connected
to the LATITUDE system if the wave lights are lit a
solid green as shown below.
Communicator Patient Manual
LATITUDE
™
27