Boston Scientific Latitude Communicateur Manuel Du Propriétaire page 24

3. Plug one end of the Communicator telephone
cord (included) into the jack labeled
4. Plug the other end of the cord into the telephone
jack on the wall.
Note: If you have DSL internet service, you may
need to use a DSL filter between the telephone
wall jack and the Communicator. Refer to "DSL
Internet Service" on page 62.
5. Optional: To use a telephone with this wall jack,
you may plug your telephone into the jack labeled
.
Note: Your Communicator and a telephone can
share the same telephone wall jack. However,
they cannot be used at the same time.
6. When the Heart button flashes, press it.
• Your Communicator's wave lights will flash
green in sequence and repeat for several
minutes as shown in "Using the Heart Button"
on page 30.
• If you have previously completed initial setup,
the Heart button will not flash at this point.
7. Your Communicator has successfully connected
to the LATITUDE system if the wave lights are lit a
solid green as shown below.
Setup is complete, and no further action is needed
at this time. Leave your Communicator plugged in.
20
LATITUDE
Communicator Patient Manual
™
.