Installation Instructions - Progress PAS3000E Notice D'utilisation

Labels supplied with the accessories
bag
Stick the adhesive labels as indicated be-
low:
1
MOD.
PROD.NO.
SER.NO
DATA
MODEL
Stick it on Guarantee Card and send
1
this part
Stick it on Guarantee Card and keep
2
this part

INSTALLATION INSTRUCTIONS

Warning! Refer to the Safety chapters.
Before the installation
Before the installation of the appliance, re-
cord the information below from the rating
plate. The rating plate is on the bottom of
the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................
Built-in appliances
• Only use the built-in appliances after you
assemble the appliance into correct built-
in units and work surfaces that align to
the standards.
Connection cable
• The appliance is supplied with the con-
nection cable.
2
MOD.
PROD.NO.
SER.NO
03 IT
DATA
MADE IN ITALY
MODEL
3
MOD.
PROD.NO.
0049 SER.NO.
Stick it on instruction booklet
3
• Replace the damaged mains cable with a
special cable (type H05BB-F Tmax 90°C;
or higher). Speak to your local Service
Centre.
To attach the seal.
• Clean the worktop in the area of the cut
out section.
• Bond the seal stripe supplied on the low-
er edge of the appliance along the outer
edge of the glass ceramic. Do not extend
it. Let stay the cut ends in the middle of
one side. When, you cut it to length (add
some mm), push the two ends together.
progress 21
TYPE
230V-50Hz
IP20