Troubleshooting - Progress PAS3000E Notice D'utilisation

20 progress

TROUBLESHOOTING

Problem
You cannot activate the appli-
ance or operate it.
An acoustic signal sounds and
the appliance deactivates.
An acoustic signal sounds
when the appliance is deacti-
vated.
The appliance deactivates.
The residual heat indicator
does not come on.
You cannot activate the outer
ring.
The sensor fields become hot.
comes on.
comes on.
and a number come on.
If you tried the above solutions and cannot
repair the problem, speak to your dealer or
the customer service. Give the data from
the rating plate, three digit letter code for
the glass ceramic (it is in the corner of the
glass surface) and an error message that
comes on.
Make sure, you operated the appliance cor-
rectly. If not the servicing by a customer
Possible cause
The appliance is not connec-
ted to an electrical supply or it
is connected incorrectly.
You touched 2 or more sensor
fields at the same time.
The STOP+GO function oper-
ates.
There is water or fat stains on
the control panel.
You put something on one or
more sensor fields.
You put something on the sen-
sor field .
The cooking zone is not hot
because it operated only for a
short time.
You decreased the heat setting
from .
The cookware is too large or
you put it too near to the con-
trols.
The Automatic Switch Off op-
erates.
The Child Safety Device or the
Lock function operates.
There is an error in the appli-
ance.
service technician or dealer will not be free
of charge, also during the warranty period.
The instructions about the customer service
and conditions of guarantee are in the guar-
antee booklet.
Remedy
Check if the appliance is cor-
rectly connected to the electrical
supply.
Activate the appliance again and
set the heat setting in less than
10 seconds.
Touch only one sensor field.
Refer to the chapter "Daily Use".
Clean the control panel.
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
If the cooking zone operated
sufficiently long to be hot, speak
to the service centre.
Start from and only increase
the heat setting.
Activate the inner ring first.
Put large cookware on the rear
cooking zones if necessary.
Deactivate the appliance and
activate it again.
Refer to the chapter "Daily Use".
Disconnect the appliance from
the electrical supply for some
time. Disconnect the fuse from
the electrical system of the
house. Connect it again. If
comes on again, speak to the
service centre.