Installation Instructions - Progress PEM6000E Notice D'utilisation

Installation Instructions

Safety instructions
Warning! This must be read!
The laws, ordinances, directives and stand-
ards in force in the country of use are to be
followed (safety regulations, proper recycling
in accordance with the regulations, etc.) In-
stallation may only be carried out by a quali-
fied electrician. The minimum distances to
other appliances and units are to be ob-
served. Anti-shock protection must be pro-
vided by the installation, for example drawers
may only be installed with a protective floor
directly underneath the appliance. The cut
surfaces of the worktop are to be protected
against moisture using a suitable sealant.
The sealant seals the appliance to the work
top with no gap. When building in, protect the
underside of the appliance from steam and
moisture, e.g. from a dishwasher or oven.
Avoid installing the appliance next to doors
and under windows. Otherwise hot cook-
ware may be knocked off the rings when
doors and windows are opened.
Warning! Risk of injury from electrical
current.
• The electrical mains terminal is live.
• Make electrical mains terminal free of
voltage.
• Follow connection schematic.
• Observe electrical safety rules.
Assembly
min. 500mm
A device must be provided in the electrical
installation which allows the appliance to be
disconnected from the mains at all poles with
a contact opening width of at least 3 mm.
Suitable isolation devices include line pro-
tecting cut-outs, fuses (screw type fuses are
to be removed from the holder), earth leak-
age trips and contractors.
min.
50mm
• Ensure anti-shock protection by in-
stalling correctly.
• The appliance must be connected to
the electrical supply by a qualified
electrician.
Warning! Risk of injury from electrical
current.
• Loose and inappropriate plug and
socket connections can make the ter-
minal overheat.
• Have the clamping connections cor-
rectly installed by a qualified electri-
cian.
• Use strain relief clamp on cable.
• In the event of single-phase or two-
phase connection, the appropriate
mains cable of type H05BB-F Tmax
90°C (or higher) must be used.
• If this appliance's mains cable is dam-
aged, it must be replaced by a special
cable (type H05BB-F Tmax 90°C; or
higher). The latter is available from the
Customer Care Department
progress 11