Guide To Problems - Faro SK07 Mode D'emploi

GUIDE TO PROBLEMS

ERRORS DURING THE CYCLES
CODE MESSAGE
ER001 Safety Cut Off
ER002 Top-up
ER003 Pressure balance
ER004 No Ready
ER005 Timeout 1
ER006 Vacuum
ER007 Timeout 2
ER008 chamber T High
ER009 chamber T Low
ER010 High Pressure
ER011 Low Pressure
ER012 High theoretic T
ER013 Low theoretic T
ER014 Delta Temperature
ER015 Vacuum Test: vacuum vacuum threshold not reached during vacuum leak test
ER016 EN 13060
ER017 EN 13060
ER018 EN 13060
ER019 Door open
ER020 Timeout water charge failed to fi ll the charge tank
ER021 Emptying water tank
MACHINE FAILURES
CODE MESSAGE
AL001 Chamber Probe Fault
AL002 Chamber Probe Fault
AL003 Band Probe Fault
AL004 Band Probe Fault
AL005 Timeout water charge
AL006 Pressure Trasducer
AL007 Door Micro
AL008 Safety Micro
AL009 Blackout
AL010 Safety Pressure
AL011 Corrupted Memory
AL012 Safety Micro
AL013 PUSH Error
AL014 POP Error
AL015 Reset Pressed
AL016 Safety Micro-switch
Machine release code:
Press the keys " ", "+" and "-" simultaneously, and wait for the end of the procedure. If the
machine has broken down, contact Faro.
DESCRIPTION
the safety temperature of the chamber or band has been exceeded
the maximum number of top-ups permitted has been exceeded
the pressure balance has not been reached
the ready temperature has not been reached
failure to reach fi nal pressure during thermodynamic discharge
the second vacuum threshold has not been reached
the sterilization conditions have not been reached
chamber temperature is above the limit allowed
chamber temperature is below the limit allowed
the pressure is above the limit allowed
the pressure is below the limit allowed
the theoretical temperature is above the limit allowed
temperature below the limit allowed
the difference between chamber temperature and theoretic
temperature is beyond the limit allowed
parameters not respected in fi rst phase of vacuum leak test
parameters not respected in second phase of vacuum leak test
failure to observe temperature limits during vacuum test
Door not closed
failed to empty the discahrge tank
DESCRIPTION
chamber probe open
chamber probe short-circuited
band probe open
band probe short-circuited
exceeding the maximum time for charging water
pressure transducer fault
unforeseen door micro contact opening
unforeseen door safety micro contact opening
blackout occurred
pressure above safety limit
memory corrupted
Door safety off
Software error
Software error
Reset button pressed
Door safety on
41 41