Safety Regulations - Faro SK07 Mode D'emploi

SAFETY REGULATIONS

Follow all instructions given in this manual.
- The autoclave should be used by staff with specifi c training in the process
of sterilization within doctor's surgeries, podiatrist's studios and beauty
centres, under the responsability of the health director.
- The device is to be used to sterilize, with steam at a temperature of
121°C or 134°C, tools, rotating instruments, reusable medical devices and
porous materials (e.g. fabrics).
- The autoclave must be installed in an especially hygienic environment.
- The device must be connected to the mains.
- The electrical system must comply with IEC 364-1 standard and the "Italian
regulations for installation of electrical systems in areas assigned for medical
use".
- Check that the supply voltage, given on the ratings plate on the rear panel
of the autoclave, corresponds to that of your mains. If in doubt, contact your
retailer.
- The autoclave plug is earthed. Ensure that you use a socket with an earth
connection and position the device so that it can be easily disconnected.
- When using an extension cable, ensure that the type of cable used is suitable
for the absorption of the equipment.
- Before using the device for the fi rst time, clean the chamber (as descri-
bed on page 42).
- Do not rest the autoclave on unstable tables or surfaces.
- Do not attempt to perform maintenance on the autoclave when the power
is on; disconnect the power supply from the mains before intervening on the
machine.
- If, during a sterilization cycle, an error message should appear, the cycle
must be repeated.
- Remove the trays with the pincers provided to avoid being burnt.
- Accidentally dropping the device may cause it to be damaged and not work
correctly; if this occurs, it should be examined by technical assistance.
- The autoclave works with distilled water (see technical specifi cations
on page 42).
Any other substance used could compromise the device's operation.
If an inappropriate liquid is introduced, consult technical assistance.
- The device in its packaging can withstand the following environmental
conditions for a period no greater than 15 weeks:
Ambient temperature from -20°C to +70°C
Relative humidity from 10% to 90%
Atmospheric pressure from 500 to 1060 mbar.
23 23