Menu Structure - Wilo W-CTRL-CC Série Notice De Montage Et De Mise En Service

English

Menu structure

The menu structure of the control system is structured as follows:
Main screen 0 Pump 1...6 1
(Pump status, actual value, (Operating mode, operating data,
setpoint) info)
Diagram 2
(Actual value controlled variable,
FU frequency)
Setpoint 3
(Setpoint 1-3, external setpoint)
Main menu 4
(Login/out, fault signals, parameter
settings, password assignment,
system info)
* only accessible for service
A description of the individual menu points can be
found in Table 2.
50
Operating mode, pump 1.1
(Manual, off, automatic)
Operating data, pump 1.2
(Type, shaft power, rated current,
rated voltage, rated frequency,
Q and H )
0
Info, pump 1.3
(Operating hours, day/total,
switching cycles)
Trigger setting 2.1
(Sampling rate for diagram in s)
Setpoint 1 3.1
(Setpoint 1; bridging time for dry-
running protection)
Setpoint 2 3.2
(Setpoint 2; interval automatic
setpoint changeover)
Setpoint 3 3.3
(Setpoint 3; interval automatic
setpoint changeover)
External setpoint 3.4
Login/logout 4.1
Fault signals 4.2 Fault signal list 4.2.1
(2 pages: current signals, list,
SMS settings)
Parameter set-up menus 4.3 System 4.3.1
(2 pages) (Automatic with/without FU,
drives on/off)
Operating parameters 4.3.2 Setpoints 4.3.2.1
refers to menu 3
Limit values 4.3.2.2
Sensor 4.3.2.3
Logic SBM/SSM 4.3.2.4
(Standby/operation, fault)
WILO SE 11/2018