Erreka VULCAN D Manuel De L'installateur page 40

INSTALLATION

Procedure
Position the front and rear supports
Mount the fork
40
Installation Manual
1 Attach the front (1) and rear (2) supports, keeping
strictly to the levels shown in the previous section.

The installer should
attachment system (welding, screwing, molding,
etc) in accordance with the composition of the
material to which the supports are attached (metal,
concrete, etc).

Attach the supports on sufficiently robust
structural elements.
O
IT IS VERY IMPORTANT TO RESPECT THE LEVELS:
If the levels are not respected, the spindle will
not make the whole open/close, meaning the
slow down system will not work.
O
Carry out the welding with the operator
withdrawn and at a distance. If not, the spindle
may become damaged from welding splatter,
which could lead to failures and oil leaks.
P240A
1 Position the fork (4) in its housing in the rear cover
(5).
2 Introduce the horizontal pin (6), crossing the fork
and the cover.
3 Secure the pin using the safety washer (7).
4 Position the caps (8) to close the housing.
P240K
choose the support