Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GENERAL SAFETY INSTRUCTIONS
1
SYMBOLS USED IN THIS MANUAL
This manual uses symbols to highlight specific texts. The
functions of each symbol are explained below:
Failure to respect the safety warnings could
lead to accident or injury.
Work sequences or procedures.
2
IMPORTANCE OF THIS MANUAL
Read this guide in its entirety before carrying
out the installation, and obey all instructions.
Failure to do so may result in a defective
installation, leading to accidents and failures.
3
ENVISAGED USE
This device has been designed for installation as part of
an automatic opening and closing system for swing
doors and gates.
This device is not suitable for installation in
inflammable or explosive environments.
4
INSTALLER'S QUALIFICATIONS
Installation
professional installer, complying with the
following requirements:
• He/she must be capable of carrying out
mechanical assemblies in doors and gates,
choosing and implementing attachment
systems in line with the assembly surface
(metal, wood, brick, etc) and the weight and
effort of the mechanism.
5
AUTOMATIC SAFETY ELEMENTS
This device complies with all current safety regulations.
However, the complete system comprises, apart from
the operator referred to in these instructions, other
elements which should be acquired separately.
The safety of the complete installation depends on
all the elements installed. Install only Erreka
components
operation.
30
Installation Manual
should
be
completed
in
order
to
guarantee
Important details which must be respected for
correct assembly and operation.
Additional information to help the installer.
}
Information on care for the environment.
Moreover, this guide provides valuable information
which will help you to carry out installation more
efficiently.
This manual is an integral part of the product. Keep
for future reference.
Failure to install or use as indicated in this
manual is inappropriate and hazardous, and
could lead to accidents or failures.
by
a
• He/she must be capable of carrying out
simple electrical installations in line with the
low voltage regulations and applicable
standards.
• He/she must be capable of carrying out
simple masonry work (digging of pits,
channels, preparation of cement).
Installation should be carried out bearing in
mind
standards
EN 12453:2017 and EN 12635:2002 +A1:2008.
Respect the instructions for all the elements
positioned in the installation.
Safety elements must be installed in order to
comply with Standard EN 12453:2017.
For further details, see "Fig. 1 Elements of the
complete installation" on page 31.
proper
EN 13241:2003 +A2:2016,
Publicité
Chapitres
Table des Matières
