Güde 40401 Traduction Du Mode D'emploi D'origine page 15

Slide the requested socket wrench fitting on the drive (item 170). Connect the air hose to the sliding nipple using a quick coupling
device. Fit the socket wrench fitting to the loosened or tightened nut or screw. Set the required direction of revolution on the control
lever (item 390) and press the release lever (item 040).
Maintenance
If you observe the following maintenance directions you will ensure a long service life of this quality product and a trouble free
operation. During the maintenance always disconnect the compressed air supply. To ensure trouble free performance of your
pneumatic tool, it is necessary to carry out everyday cleaning and regular lubrication. Use only special pneumatic oil.
d) Using oil atomiser
Comprehensive maintenance unit which consists of an oil atomiser and it is located in the compressor.
e) Using an oiling can installed into the piping
Install a lubricating device into the piping in an immediate vicinity of the tools (distance of about 50 cm), the lubricating device supplies
the tools with a sufficient amount of oil. If the pneumatic machine is out of work for several days, you must use 5-10 drops of special
tool oil for the pneumatic connecter
f) Hand lubrication
If you do not have the maintenance unit or the lubricating device installed into the piping at your disposal, you must use 3-5 drops of
special tool oil for the pneumatic connecter before each start-up of the impact fastener. Pneumatic tools should be stored in dry
rooms.
Direct grinder
Never aim at yourself or other persons with the rotating machine end. Connect the machine to the air supply hose.
Technical data
Connecting thread
Operational pressure
Air consumption
Revolutions
Maintenance
Maintenance can be done only by people with necessary qualifications.
If you observe the following maintenance directions you will ensure a long service life of this quality product and a trouble free
operation. During the maintenance always disconnect the compressed air supply. To ensure trouble free performance of your
pneumatic tool, it is necessary to carry out everyday cleaning and regular lubrication. Use only special pneumatic oil.
In terms of lubrication you have the following options:
a) Using oil atomiser
Comprehensive maintenance unit which consists of an oil atomiser and it is located in the compressor.
b) Using an oiling can installed into the piping
Install a lubricating device into the piping in an immediate vicinity of the tools (distance of about 50 cm), the lubricating device supplies
the tools with a sufficient amount of oil. If the pneumatic machine is out of work for several days, you must use 5-10 drops of special
tool oil for the pneumatic connecter
c) Hand lubrication
If you do not have the maintenance unit or the lubricating device installed into the piping at your disposal, you must use 3-5 drops of
special tool oil for the pneumatic connecter before each start-up of the impact fastener. Pneumatic tools should be stored in dry
rooms.
15
¼"
6 bar
app. 350 l/min.
22000 rpm