Technical Data; Air Consumption - Güde 40401 Traduction Du Mode D'emploi D'origine

Start up
Screw the nipple, part of the delivery, into the pneumatic connection (item E) and fasten it with a Teflon tape. The fitting needed is slid
into the square (item A). Set the right direction of revolution (item B) on the switching lever:
Pressing backwards (reverse) left hand operation = screw loosening
Pressing forwards (forward) right hand operation = screw tightening
Install the fitting into the screw knob. Press the trigger (item C). It is possible to control the air supply with the air control (item D).
Mark 9 = max. tightening torque (4)
Mark 0 = min. tightening torque (1)
A flexible pneumatic hose with a quick coupling device is used for the connection to the compressed air supply.
Maintenance
If you observe the following maintenance directions you will ensure a long service life of this quality product and a trouble free
operation. During the maintenance always disconnect the compressed air supply. To ensure trouble free performance of your
pneumatic tool, it is necessary to carry out everyday cleaning and regular lubrication. Use only special pneumatic oil.
a) Using oil atomiser
Comprehensive maintenance unit which consists of an oil atomiser and it is located in the compressor.
b) Using an oiling can installed into the piping
Install a lubricating device into the piping in an immediate vicinity of the tools (distance of about 50 cm), the lubricating device supplies
the tools with a sufficient amount of oil. If the pneumatic machine is out of work for several days, you must use 5-10 drops of special
tool oil for the pneumatic connecter
c) Hand lubrication
If you do not have the maintenance unit or the lubricating device installed into the piping at your disposal, you must use 3-5 drops of
special tool oil for the pneumatic connecter before each start-up of the impact fastener. Pneumatic tools should be stored in dry
rooms.
Chipping hammer
Never aim at yourself or other persons with the rotating machine end. Connect the machine to the air supply hose.

Technical data

Connecting thread
Operational pressure

Air consumption

Impact number
Maintenance
Maintenance can be done only by people with necessary qualifications.
If you observe the following maintenance directions you will ensure a long service life of this quality product and a trouble free
operation. During the maintenance always disconnect the compressed air supply. To ensure trouble free performance of your
pneumatic tool, it is necessary to carry out everyday cleaning and regular lubrication. Use only special pneumatic oil.
In terms of lubrication you have the following options:
a) Using oil atomiser
Comprehensive maintenance unit which consists of an oil atomiser and it is located in the compressor.
b) Using an oiling can installed into the piping
Install a lubricating device into the piping in an immediate vicinity of the tools (distance of about 50 cm), the lubricating device supplies
the tools with a sufficient amount of oil. If the pneumatic machine is out of work for several days, you must use 5-10 drops of special
tool oil for the pneumatic connecter
c) Hand lubrication
If you do not have the maintenance unit or the lubricating device installed into the piping at your disposal, you must use 3-5 drops of
special tool oil for the pneumatic connecter before each start-up of the impact fastener. Pneumatic tools should be stored in dry
rooms.
Attention:
Replace the spring occasionally (drawing of a dismantled tool – item 1)
¼ "
6 bar
350 l/min.
3000/min.
13