Working Capacity (Max. Thread Size); Square Clamp; Item Description; Release Lever - Güde 40401 Traduction Du Mode D'emploi D'origine

Screwdriver with ratchet
Technical data
Idle speed
Capacity
Max. loosening torque

Working capacity (max. thread size)

Max. admissible work pressure
Noise emission
under DIN 45635 part 20 / 09.90
Acoustic performance level L
Emission level for workplace L
Maximal level of measuring area impulse acoustic pressure L
max, 1m
Vibrations (loaded)
under DIN EN 28662 part 1 / 01.93
or E DIN ISO 8662 part 1 / 01.93

Square clamp

Air consumption
Recommended inner hose cross section
Weight
Air quality needed:
Compressor capacity:
Adjusting values for work:
Illustration
Item Description
040

Release lever

170 Drive
390 Switching lever for right/left
operation
430 Pneumatic nipple connector

Using the tool for its purpose

The screwdriver with ratchet is an easy-to-use pneumatic tool for craftsmen. It is very suitable for work on cars, motorcycles,
agricultural equipment or assembly belts, in particular at hard to access places. To reach the maximal tightening torque it is not
admissible to use any further manual tightening using the screwdriver. Air escapes through the front part of the machines. The
pneumatic connecter is equipped with a quick coupling device.

Safety provisions

Protect yourself and your surroundings by preventing any accident risks.

- Screwdriver with ratchet should not be used for any other purpose than it has been designed for.
- Don't touch rotating parts.
-

Pneumatic tools should be kept away from children.

-

Work only once you are fully concentrating and feel rested.

-

Use a coupling with a quick closing device for pneumatic connection.

-

Working pressure should be set using the control valve.

-

Do not use oxygen or gaseous fuel as energy supplies.

-

Disconnect the machine from the compressed air supply before starting to repair a possible defect.

-

Use only original spare parts.

- Don't let the machine unloaded at full idle speed.
- Wear necessary protective clothing when working with screwdriver with fastener.
Start up
A sliding nipple which is a part of the delivery (item 403) should be screwed into the reducing nipple. Use a ring spanner or a fork
wrench. Attention: Thread is to be fastened with a Teflon tape.
WAI max. c
PAI max.
Clean with oil mist:
Compressor charging capacity: 180 l/min.
Corresponds to 1,5 kW.
Working pressure setting on the pressure reducing
valve or filter reducing valve 6 bars.
160 rev./min
0,272 kW
40 Nm
M 8
6 bar
103 dB (A)
93 dB (A)
90 dB (A)
PAI
14,7 m/sec
½ inch
ca 310 l/min
6 mm
1,24 kg
14
2