Table Des Matières - Güde 40401 Traduction Du Mode D'emploi D'origine

Impact fastener
Technical data
Capacity
Max. torque for loosening
Max. torque for fastening
Revolutions
Working capacity (max. thread size)
Max. admissible working pressure
Acoustic pressure level
Vibration (loaded)
Square clamp
Air consumption
Recommended hose cross section, inner
Weight
Air consumption at max. fastening torque
Air quality needed, air supply:
Clear air with oil mist. Use a maintenance unit with a filter reducing valve and an oil atomizer. .
Adjusting working values:
Working pressure set on the pressure reducing valve is 6 bars.
Illustration
Item Description
A Square for nut fastening
(drive shaft)
B Lever for switching over from left to right
C Release lever
D Air regulator or tightening torque regulator
E Pneumatic connector
Using the tool for its purpose
The impact fastener is an easy-to-use pneumatic tool for craftsmen. It is suitable for fastening and loosening of screwed connections
in cars (tyre fitting, dead chassis screws), for assembly belts or in agriculture.
Air escapes through the side outlet. Fitting a replacement is very easy and quick. Pneumatic connector is equipped with a quick
coupling device. When fastening screws and nuts you should observe the necessary tightening torques. For tightening use the torque
key.
Please observe the following directions:
When working with the impact fastener wear appropriate protective clothing.
Observe safety regulations.
Safety provisions
Protect yourself and your surroundings by preventing any accident risks.
- Impact fastener should not be used for any other purpose than it has been designed for.
- Pneumatic tools should be kept away from children.
- Work only once you are fully concentrating and feel rested.
- Use a coupling with a quick closing device for pneumatic connection.
- Working pressure should be set using the control valve.
- Do not use oxygen or gaseous fuel as energy supplies.
- Disconnect the machine from the compressed air supply before starting to repair a possible defect.
- Use only original spare parts.
- Don't let the machine run unloaded at full idle speed.
- Wear necessary protective clothing when working with impact fastener.
~0,34 kw
310 Nm
250 Nm
7000 rpm
M 16
6 bar
89 db (A)
< 2,5 m/sec²
½ inch
ca 6 l/sec.
9 mm
2,3 kg
ca 350 l/min.
12